Jay's Ceramic Wash Shampoo is infused with SiO2 nanoparticles to leave behind a high-gloss, water-beading finish that protects your vehicle's paint from harsh environmental elements. Create a super durable layer of paint protection that helps repel water, dirt, UV rays, and other environmental pollutants. For best coating results, we recommend allowing the finish to cure for 6-8 hours after the wash is complete.
We've spent countless hours developing a formula that not only leaves behind a beautifully glossy finish but also cleans with thick, dirt-clinging foam. Gently encapsulate dirt particles and lift them away from the surface to help avoid dreaded swirl marks & scratching. Great for use with a hose & bucket, a low-pressure foam gun, or a full foam cannon and pressure washer setup.
Other ceramic soaps on the market boast water-beading capabilities, but lack slickness and the foaming ability that is indicative of a quality wash shampoo. We've worked closely with our chemists to develop a formula that can deliver both: slick, foaming suds plus durable ceramic protection!
Ceramic-coated paint stays cleaner longer and is easier to detail when it is dirty. Use Ceramic Wash Shampoo to replenish your existing coating or use to wash a non-coated car and enjoy standalone protection that saves time & money.
Great for use with a traditional hose & bucket, with a foam gun, or even a pressure washer & foam cannon setup. If using a traditional hose & bucket, we suggest using the two-bucket car wash method.
Directions for use with 5-gallon bucket:
1. Add 2-4 ounces of soap to an empty bucket. Spray a pressurized blast of water to fill the bucket and produce loads of luxurious suds.
2. Wash car or truck with your normal wash routine.
3. Allow 6-8 hours after wash is complete for ceramic to cure.
Directions for use with a foam gun or foam cannon setup:
1. Fill the water/soap reservoir with clean water until almost full. Note if there are any fill lines printed on the bottle.
2. Add 2-4 ounces of soap to the water/soap reservoir.
3. Attach to foam gun/cannon and use per manufacturer's instructions.
4. Wash car or truck with your normal routine.
5. Allow 6-8 hours after wash is complete for ceramic to fully cure.
California Ingredient Disclosure - Cleaning Products Right to Know Act 2017 (CA-RTK)
|Name of Substance||CAS No||Functionality||Authoritative Lists|
|sodium laureth sulfate||68585-34-2||surfactant|
|Sodium 2-(2-dodecyloxyethoxy)ethyl sulphate||3088-31-1||surfactant|
|sodium chloride||7647-14-5||viscosity modifier|
|polyethylene oxide lauryl ether||9002-92-0||surfactant|
|ethoxylated C11-15 secondary alcohols||68131-40-8||surfactant|
Safety Data Sheet (SDS) can be downloaded from our website. Note that OSHA's Hazard Communication Standard has different disclosure than CA-RTK. Therefore, the information contained in Section 3 of the SDS may not exactly match the information in this disclosure.
Product is just as advertised Not as common today as it should be. ! Adds to the Ceramic coating that was applied to car.
Unbelievable results! Corvette paint looked like it was liquid after washing.
Ceramic wash shampoo is great and easy to use I’m hooked
Goes on nice and rinse off with ease , finished with micro soft drying . When all finished I applied the glossy spray protective coating! Show room beauty
The staff at Jay Leno's garage have done it again! The ceramic shampoo works great on my vehicles! I'm impressed with the shiny results!